However this time after just a few seconds of clicking "OK", the system rebooted. June 2020, I installed the same software on a new computer I recently assembled running on the latest Windows 10 update. I went through the above License Server configuration process and when it got to the step where it says that the FLEXid 9 dongle driver needs to be installed, I clicked "OK" as usual. The FLEXID information is correctly shown on the System Settings at LMTOOLS and the license service works.įast forward. Like I said above, though it shows the above message, everything still works as intended. Failed to update your CDS_LIC_FILE license path with the new license server setting ".". ![]() "- Unable to restart Cadence License Server with the new license file ". and it gives the message below (which I always ignore because at the end the license/dongle still work as intended and the software is usable). I always click "OK" and it does its thing. Click OK to continue or Cancel to terminate the Cadence License Server Configuration utility" The driver installation process may take a few minutes. Please make sure to connect your FLEXid USB dongle to an available USB port. "Cadence License Server Configuration utility has detected that it needs to install the FLEXid 9 dongle driver on your system. because our company has a few), I always get this message at the very last step: When I installed my ORCAD on a Windows 10 computer a while back, every time I run the Cadence License Server Configuration (when I swap USB dongle/license. ![]() Software: ORCAD PCB Designer Professional
0 Comments
Leave a Reply. |